|
issued by ASTM
5.1 This is a sensitive, noncontact, and nondestructive method for measuring the coating thickn...
|
|
|
issued by ASTM
2.1 This practice is designed to locate the thinnest portions of the zinc coating on newly coat...
|
|
|
issued by NACE
This standard describes requirements and guidelines for ways of organizing and maintaining the ...
|
|
|
issued by ASTM
4.1 Paint spatter generated by roller application is dependent on the properties of both the pa...
|
|
|
issued by ASTM
5.1 During construction of a home, paints are subjected to a wide variety of drying conditions,...
|
|
|
issued by ASTM
4.1 Until the paint brush is fully conditioned and wetted with paint, only part of the paint lo...
|
|
|
issued by ASTM
5.1 For proper bonding of overlays and coatings, it is important that a concrete surface have ...
|
|
|
issued by SSPC
This standard is one of four separate standards that replace SSPC-SP 12/NACE No. 5, which has b...
|
|
|
issued by SSPC
This standard is one of four separate standards that replace SSPC-SP 12/NACE No. 5, which has b...
|
|
|
issued by SSPC
This standard is one of four separate standards that replace SSPC-SP 12/NACE No. 5, which has b...
|
|
|
issued by SSPC
This standard is one of four separate standards that replace SSPC-SP 12/NACE No. 5, which has b...
|
|
|
issued by SSPC
This standard describes a procedure for determining shop or conformance to a specified coating ...
|
|
|
issued by Green Seal
This standard establishes environmental requirements for industrial and institutional floor-car...
|
|
|
issued by ASTM
Water can cause the degradation of coatings, so knowledge of how a coating resists water is hel...
|
|
|
issued by ASTM
The thickness of a coating is often critical to its performance. For some coating-substrate com...
|
|
|
issued by ASTM
Tensile properties determined by this method are of value in studying the behavior of coatings ...
|
|
|
issued by ASTM
The pull-off strength of a coating is an important performance property that has been used in s...
|
|
|
issued by ASTM
This practice describes the procedures that can be used to prepare new and weathered zinc-coate...
|
|
|
issued by ASTM
The thickness or mass per unit area of a coating is often critical to its performance.
|
|
|
issued by ASTM
The final appearance of a paint brush after it has been used and cleaned is related to the abil...
|
|
|
issued by ASTM
This specification covers generally recognized requirements for the cautionary labeling to be p...
|
|
|
issued by ASTM
1.1 This test method covers the use of eddy-current instruments for the nondestructive measurem...
|
|
|
issued by ASTM
1.1 These practices cover four types of treatment for preparation of aluminum and aluminum-allo...
|
|
|
issued by ASTM
1.1 These practices describe procedures for the preparation of hot-dip aluminum surfaces for pa...
|
|
