INDUSTRIAL COATINGS PREVIOUS QUIZZES


THURSDAY, NOVEMBER 14, 2019
What is another name for the coating failure term “bleeding"?

WEDNESDAY, NOVEMBER 13, 2019
True or false: Jet fire tests are not used to determine the heat-insulating capabilities of intumescent coatings in cellulosic fires.

TUESDAY, NOVEMBER 12, 2019
True or false: With respirator use during abrasive blasting, the approved air hose from the respirator manufacturer must be used.

MONDAY, NOVEMBER 11, 2019
True or false: In a study of shop-applied topcoats reported in JPCL, a polyaspartic coating performed best in resisting handling damage in the shortest amount of time at lower temperatures (50°F) and higher humidity (75% RH).

FRIDAY, NOVEMBER 8, 2019
True or false: The Construction Specifications Institute offers a standard that gives durability grades of low, medium and high for paint systems in various environments and levels of surface preparation.

THURSDAY, NOVEMBER 7, 2019
True or false: For work in hazardous environments, OSHA requires work practice and engineering controls to mitigate the hazards before respiratory protection is employed.

WEDNESDAY, NOVEMBER 6, 2019
Who said “that the third-party inspection system is fundamentally flawed in that it creates an inherent atmosphere of adversity between the contractor and inspector, rather than one of collaboration"?

TUESDAY, NOVEMBER 5, 2019
True or false: Some instruments used to test moisture in concrete or masonry walls are based on the principle of electrical impedance.

MONDAY, NOVEMBER 4, 2019
Which of the following words describing a characteristic of pigments does not fit with the other three?

FRIDAY, NOVEMBER 1, 2019
True or false: SSPC’s wet abrasive blast cleaning standards describe three levels of flash rust following wet blast cleaning.

THURSDAY, OCTOBER 31, 2019
What organization is advising SSPC and NACE during merger talks?

WEDNESDAY, OCTOBER 30, 2019
True or false: At the DoD-Allied Nations Technical Corrosion Conference this year, one presentation dealt with the use of dry ice for cleaning topside and non-skid ship coatings.

TUESDAY, OCTOBER 29, 2019
What happens to the existing profile on steel when UHP water blasting is used to remove rust and/or coatings?

MONDAY, OCTOBER 28, 2019
True or false: Duplex galvanizing is the name of the alloy coating comprised of tin and zinc, which is sometimes used to coat stainless steel.

FRIDAY, OCTOBER 25, 2019
True or false: In addition to the current effort, SSPC and NACE last had extended discussions about a merger in 1985-86.

THURSDAY, OCTOBER 24, 2019
What organization has published a classification system for textures of floor coating finish coats and a set of tactile comparators?

WEDNESDAY, OCTOBER 23, 2019
True or false: The breathing air of a supplied air respirator can be a potential inhalation hazard to abrasive blasters.

TUESDAY, OCTOBER 22, 2019
What organization certifies long-term guarantees on tank linings and other protective coating work?

MONDAY, OCTOBER 21, 2019
True or false: Although OSHA has authorized use of drones for inspections, the agency has not confirmed their actual use.

FRIDAY, OCTOBER 18, 2019
Extender pigments are often classified into four groups: sulfates, carbonates, oxides and what other group?

THURSDAY, OCTOBER 17, 2019
True or false: The adhesion of a coating to a steel substrate depends partially upon chemical bonding of the coating to the steel.

WEDNESDAY, OCTOBER 16, 2019
True or false: OSHA has stated that where the definition of a Construction Industry versus a General Industry confined space is unclear, compliance with the Construction Industry confined space standard will also be considered to be compliance with the General Industry confined space standard.

TUESDAY, OCTOBER 15, 2019
True or false: SSPC’s Fundamentals of Protective Coatings e-course is available in Mandarin Chinese.

MONDAY, OCTOBER 14, 2019
True or false: Vinyl esters are easy to apply.

FRIDAY, OCTOBER 11, 2019
True or false: Conformance with specified requirements for cleanliness of steel after surface preparation, as described in SSPC standards, is carried out without the aid of instruments.

THURSDAY, OCTOBER 10, 2019
True or false: A special visual standard and guide has been developed to support SSPC-SP 17, Thorough Abrasive Blast Cleaning of Non-Ferrous Metals.

WEDNESDAY, OCTOBER 9, 2019
True or false: Zinc dust is an inhibitive pigment.

TUESDAY, OCTOBER 8, 2019
True or false: Particles of concrete dislodged from a concrete substrate by abrasive blasting do not pose any inhalation hazards.

MONDAY, OCTOBER 7, 2019
True or false: Anatase and rutile are types of Isocyanates.

FRIDAY, OCTOBER 4, 2019
Which one of the following organizations does not train and certify paint inspectors?

THURSDAY, OCTOBER 3, 2019
True or false: SSPC has one PCCP/QP standard that is jointly issued with NACE.

WEDNESDAY, OCTOBER 2, 2019
Who is the author of the book described as follows: “The author’s research into 84 failure cases provides extensive information about the causes of coating failures—from blister failures to solvent entrapment and discontinuities in coating films. The book also contains historical data and case studies from research involving coating and lining failures, materials selection and application methods for protective coatings.”

TUESDAY, OCTOBER 1, 2019
True or false: Breathing-grade compressed air (Grade D, as specified by the Compressed Gas Association) must contain at least 25% oxygen by volume.

MONDAY, SEPTEMBER 30, 2019
True or false: The skills required for fabrication, coating and maintenance of offshore oil and gas platforms are easily transferrable to the offshore wind turbine sector, according to a PaintSquare writer.

FRIDAY, SEPTEMBER 27, 2019
Among these workplace hazards, which one is not one of OSHA’s “Fatal Four?”

THURSDAY, SEPTEMBER 26, 2019
True or false: You can measure the relative humidity adjacent to bridge steel as long as you are within 100 feet of the bridge.

WEDNESDAY, SEPTEMBER 25, 2019
True or false: Recent technical developments have made dry ice blasting competitive with air abrasive blasting using conventional abrasive material, according to a PaintSquare writer.

TUESDAY, SEPTEMBER 24, 2019
Mango leaf extract is being studied for what application?

MONDAY, SEPTEMBER 23, 2019
In its degree of cleaning, SSPC-SP 14 sits between what other two SSPC blast cleaning standards?

FRIDAY, SEPTEMBER 20, 2019
True or false: In fiscal year 2018, OSHA investigations of whistleblower complaints decreased from complaints investigated in the previous year.

THURSDAY, SEPTEMBER 19, 2019
True or false: A manufacturer’s claims that a microbicidal coating kills 99.9% of certain infectious bacteria does not require verification testing by the EPA.

WEDNESDAY, SEPTEMBER 18, 2019
What polymer concrete resin is based on an alcohol derived from agricultural wastes such as rice and oat hulls and corn cobs?

TUESDAY, SEPTEMBER 17, 2019
What is the name of an accelerated weathering apparatus that operates on a condensation type of water exposure at elevated temperature?

MONDAY, SEPTEMBER 16, 2019
True or false: Several methods can be used to minimize or prevent flash rusting after abrasive blast cleaning of steel.

FRIDAY, SEPTEMBER 13, 2019
True or false: SSPC-SP 11, which requires a one-mil profile, is titled “Commercial Grade Power Tool Cleaning.”

THURSDAY, SEPTEMBER 12, 2019
True or false: In atmospheric weathering exposures, aromatic polyureas perform much better than aliphatic polyureas in retaining elastomeric properties.

WEDNESDAY, SEPTEMBER 11, 2019
True or false: NACE International held a corrosion awareness day in Aberdeen, Scotland, last month.

TUESDAY, SEPTEMBER 10, 2019
True or false: The acronym CAS stands for both Chemical Abstract Service and Coating Application Specialist.

MONDAY, SEPTEMBER 9, 2019
True or false: SSPC Coatings+ is expected to attract 1,500 coatings professionals in Long Beach, California, in February 2020.

FRIDAY, SEPTEMBER 6, 2019
True or false: Abrasive blast workers are not regularly exposed to noise in excess of 120 dBA.


Today's Quiz

Advertisements
 
KTA-Tator, Inc. - Corporate Office

 
Fischer Technology Inc.

 
DeFelsko Corporation

 
ABKaelin, LLC

 
NLB Corporation

 
SAFE Systems, Inc.

 
Mitsubishi Gas Chemical America

 
HoldTight Solutions Inc.

 
Sidewinder/Persyst Enterprises, Inc.

 
 
 

Technology Publishing Co., 1501 Reedsdale Street, Suite 2008, Pittsburgh, PA 15233

TEL 1-412-431-8300  • FAX  1-412-431-5428  •  EMAIL webmaster@paintsquare.com


The Technology Publishing Network

PaintSquare the Journal of Protective Coatings & Linings Paint BidTracker

 
EXPLORE:      JPCL   |   PaintSquare News   |   Interact   |   Buying Guides   |   Webinars   |   Resources   |   Classifieds
REGISTER AND SUBSCRIBE:      Free PaintSquare Registration   |   Subscribe to JPCL   |   Subscribe to PaintSquare News
MORE:      About PaintSquare.com   |   Privacy Policy   |   Terms & Conditions   |   Support   |   Site Map   |   Search   |   Contact Us