PaintSquare Daly News on Tablet
PaintSquare Daily News is available in three editions:
Industrial Only
Commercial Only
Combined Industrial & Commercial

Your free subscription also includes:
Special topical editions and Weekend Brief—a recap of the week’s top news and some great in-depth reads.

Subscribe now:


Comment |

OSHA's Slips, Trips and Falls Rule Revamped


By Eric J. Conn

On Jan. 17, 2017, the Occupational Safety and Health Administration’s new Walking-Working Surfaces Rule took effect, updating OSHA regulations that have been in place for nearly a half century. OSHA’s new rule, commonly referred to as the “Slips, Trips and Falls” rule, actually revises and updates two historic OSHA standards—the Walking-Working Surfaces regulations at Subpart D and the Personal Fall Protection regulations at Subpart I of OSHA’s General Industry Standards (29 C.F.R. Part 1910). 

Begun in 1990, the rule revision took OSHA all of 27 years—longer than it takes the agency to promulgate its comprehensive health standards, which is saying quite a bit. But just shy of two months before the end of the Obama administration, the rule was promulgated, and became effective and enforceable three days prior to the inauguration of President Donald Trump.

Safety harness
© / ThamKC

OSHA’s new rule, commonly referred to as the “Slips, Trips and Falls” rule, actually revises and updates two historic OSHA standards.

While the new rule may fall prey to to efforts by the Trump Administration to stay and roll back those rules promulgated in the 11th hour by the Obama administration—of which this certainly is one—it seems to have avoided the full-scale assault by industry legal challenges typical of new OSHA rules.

The period to file legal challenges to the rule ended two weeks ago, and a survey of court filings indicates that only two parties have filed challenges to the rule, and these challenges are narrowly focused on a few discreet provisions of the rule, relating to the 300-foot limit on the use of rope descents and the restrictions on chimney sweeps who climb carrying their hook ladders. Thus, even if these challenges are upheld, the bulk of OSHA’s revised Walking Working Surfaces rule will remain secure and in place.

Significant Provisions of the New Standard

It is not surprising that the new rule by and large escaped industry legal challenge. For the most part, it incorporates existing advances in technology and current national consensus standards and/or industry best practices already in place in a wide swath of impacted industries into the regulatory structure. Further, particularly in the area of personal fall protection, the new rule adds flexibility to the old requirements by expanding allowable methods for compliance. For instance, the new rule allows employers to rely on fall-protection systems rather than relying exclusively on guardrails and physical barriers in many situations.

However, the new rule does impose some new requirements it is important to be aware of and understand. Where personal fall protection systems are used (i.e., personal fall arrest, travel restraint, and positioning systems), the new standard establishes requirements on the use, performance, and maintenance of these systems.

Also, as has been the case under OSHA’s construction standards for some time, the final rule prohibits the use of body belts as part of a personal fall arrest system. This is one example of many where the new standard eases compliance for employers with operations governed by both the general industry as well as construction standards by, in general, aligning the regulatory provisions in these two areas.

More broadly, the new standard adopts new requirements in the areas of training and inspection, requiring employers to, for instance, inspect walking-working surfaces regularly and as needed, and to correct, repair or guard against hazardous conditions, and to train and retrain (as necessary) all employees who use personal fall protection and work in other specified high hazard situations on fall and equipment hazards, including fall-protection systems.

With regard to ladders, the new standard phases in new ladder requirements, including a requirement to equip fixed ladders extending over 24 feet with ladder safety or personal fall arrest systems, and prohibits the use of cages and wells as a means of fall protection after the elongated 20-year phase-in deadline. While the rule grandfathers in cages and wells on existing ladders, it requires during the phase-in period that employers equip new ladders and replacement ladders or ladder sections with ladder safety or personal fall arrest systems.

The compliance deadlines established in the rule include:

  • Training workers on fall and equipment hazards—six months;
  • Inspection and certification of permanent building anchorages—one year;
  • Installation of fall protection (personal fall arrest systems, ladder safety systems, cages, wells) on existing fixed ladders (over 24 feet) that do not have any fall protection—two years;
  • Installation of ladder safety or personal fall arrest systems on new fixed ladders (over 24 feet) and replacement ladders/ladder sections—two years; and
  • Installation of ladder safety systems or personal fall arrest systems on all fixed ladders (over 24 feet)—20 years.

Key Concession on Rolling Stock

A point of great contention over the course of the decades long rulemaking was whether OSHA would include new provisions and fall protection requirements applicable to rolling stock and motor vehicles.

OSHA defines “rolling stock” as “any locomotive, railcar, or vehicle operated exclusively on a rail or rails, or a trolley bus operated by electric power supplied from an overhead wire.” A “motor vehicle” is defined as “any commercial bus, van, or truck, including tractor trailer, flatbed, tanker, and hopper trucks.”

Tanker railcar
© / majorosl

A point of great contention over the course of the decades long rulemaking was whether OSHA would include new provisions and fall protection requirements applicable to rolling stock and motor vehicles.

An earlier proposal of the rule included a data request asking stakeholders to provide information related to regulation of vehicles falling under these definitions. Numerous stakeholders, from industry groups to safety organizations, provided comment during the rulemaking on whether the final rule should include specific requirements for fall protection on top of rolling stock and motor vehicles. Thus, while OSHA did not include specific requirements applicable to rolling stock in its 2010 proposed rule, it noted in the preamble to the 2010 proposal that it would continue gathering data and evidence to determine whether there is a need to propose specific fall protection requirements for rolling stock and motor vehicles.

The agency further noted in 2010 that it needed “more information about what employers are presently doing and any feasibility and cost concerns associated with a requirement to provide protection” for rolling stock and motor vehicles.

Notwithstanding the signals OSHA was sending during the rulemaking process, the final standard contains no new fall protection requirements applicable to rolling stock.  Thus, the “Miles Memo” remains in place, and it requires the use of fall protection on rolling stock in situations where railcars are located adjacent to an elevator or other permanent structure.

Of additional import, while the new standard does not create additional fall protection requirements for rolling stock beyond the Miles Memo, the preamble does state that feasibility of fall protection is more clear today than when the Miles Memo was was issued, and that OSHA will “wait until the record is more fully developed” to make a determination about requiring fall protection on rolling stock and motor vehicles at all times.

Further, the agency stated that, if it receives sufficient comments and evidence to warrant rulemaking on rolling stock and motor vehicles in the future, it will issue “a separate proposed rule” specifically targeting and addressing this issue. Thus, OSHA has kept the door open to developing a further stand-alone rule on rolling stock.


Overall, the new rule is relatively non-controversial and has received more support from industry than most OSHA rules, evidenced by the lack of judicial petitions filed challenging the rule. Nonetheless, it contains some new requirements that employers must be aware of, such as the new training and inspection requirements that kick in in six and 12 months, respectively.

Stay tuned to see whether the standard falls within the scope of efforts by the Trump Administration to stay its terms or enforcement, but, until then, make sure to review and understand both the new requirements of the standard as well as the additional flexibility it provides to protect workers from falls in your workplaces.


Eric J. Conn

Eric J. Conn is a founding partner of Conn Maciel Carey and Chair of the firm’s national OSHA • Workplace Safety Group. His practice focuses exclusively on issues involving occupational safety and health law. OSHA Watch offers general information but should not be construed as legal advice. Employers are always advised to seek appropriate counsel for individual issues. Contact Eric.



Tagged categories: Epstein Becker Green; Health & Safety; Health and safety; Laws and litigation; OSHA; Access; Fall protection; Ladders; Regulations; Safety; Safety equipment

Comment from Thomas Van Hooser, (5/11/2017, 8:44 AM)

Precautions for temporary ladders/access should also be addressed in the proposed new standard.

Comment Join the Conversation:

Sign in to our community to add your comments.

Modern Safety Techniques


Key Resin Company

Tarps manufacturing, Inc.

base painters

Quikspray, Inc.

PreTox Products - NexTec, Inc.

Paint BidTracker

NLB Corporation


Technology Publishing Co., 1501 Reedsdale Street, Suite 2008, Pittsburgh, PA 15233

TEL 1-412-431-8300  • FAX  1-412-431-5428  •  EMAIL

The Technology Publishing Network

PaintSquare the Journal of Protective Coatings & Linings Paint BidTracker

EXPLORE:      JPCL   |   PaintSquare News   |   Interact   |   Buying Guides   |   Webinars   |   Resources   |   Classifieds
REGISTER AND SUBSCRIBE:      Free PaintSquare Registration   |   Subscribe to JPCL   |   Subscribe to PaintSquare News
MORE:      About   |   Privacy Policy   |   Terms & Conditions   |   Support   |   Site Map   |   Search   |   Contact Us