Click to Purchase and Download this Standard or Test Method
Revision Date: November 01, 1982
Updated On: April 01, 2002
Editorial Change: November 1, 2004
This specification outlines a three-coat epoxy polyamide painting system for the protection of steel surfaces subject to industrial exposure, marine environments, and areas subject to chemical exposure such as acid and alkali.
This system, when properly applied and cured, is capable of giving excellent protection to steel surfaces in Environmental Zones 2A (frequently wet by fresh water), 2B (frequently wet by salt water), 3A (chemical exposure, acidic), 3B (chemical exposure, neutral), and 3C (chemical exposure, alkaline), but not in potable water tanks. Although the coating herein specified has exhibited good chemical protection, its resistance against specific chemicals should, in the absence of applicable case histories, be appropriately tested.
Blastox - One Step Lead Abatement
Don't waste $$ on added labor steps with other methods. Don't mix, meter or apply at the job-site. Avoid strict hazardous waste rules. Let your painters paint!
From Detection to Correction
Corrosion Probe, Inc. has the Most Concrete Coatings Experience and Expertise. Contact us today at
Rubber In a can! Rubberized Spray in a Handy Aerosol Can
• Stays flexible
• Seals off moisture penetration
• Non sagging formulation
• Will not crack, chip or peel
• Apply to wet and dry surfaces
Need a Dry-O-Lite Refill?
Order Dry-O-Lite desiccant from Van Air Systems. The dependable, and cost-effective solution for dry compressed air.