Click to Purchase and Download this Standard or Test Method
Updated On: October 22, 2013
This standard covers the manufacture of circumferentially reinforced concrete pressure pipe, without a steel cylinder and not prestressed, in sizes from 12 to 144 in. (300 to 3,660 mm) inclusive and for working pressures not exceeding 55 psi (380 kPa) and for working plus surge pressures not exceeding a total pressure of 65 psi (450 kPa). This type of pipe is designed for the internal pressure, external loads, and bedding conditions designated by the purchaser. Pipe of diameters larger than 144 in. (3,660 mm) have been manufactured based on the concepts of this standard. This standard does not include requirements for design, handling, delivery, laying, field testing, or disinfection of pipe. The pipe shall have the following principal features: a reinforcing cage or cages of steel rods, bars, wire, or fabric; a wall of concrete covering the reinforcing cage or cages inside and out; and a joint with a preformed rubber gasket or gaskets of rubber of circular cross section, so designed that the joint will be watertight under all conditions of service. The purpose of this standard is to provide purchasers, manufacturers, and constructors with the minimum requirements for reinforced concrete pressure pipe, noncylinder type, including fabrication and testing requirements.
The Blast Pak
Van Air Systems' portable desiccant air dryer. Get dry compressed air with this All-In-One blasting and coating solution.
Wasser Coatings Protect
some of the most important bridges in the country; learn about our NEPCOAT-approved system and our entire range of MCU & Polyurea coatings.
High Temperature Paint
• Prevent Rust / Corrosion
• High Build / Hot Apply
• Custom Colors / VOC-Compliant
• Offshore/Petro Chem/ Refining/Power Industries
• Over 90 Years of Experience
GMA Garnet™ Natural Abrasives
- Superior cleaning performance
- Even Profile
- Low Dust
- Environmentally friendly
- Recyclable up to 5 times
Tel : +1 832 243 9300